THYOSIL E1549

Selfcrosslinking acrylic emulsion 封底自膠聯丙烯酸乳液（底漆，面漆用）

Description描述

THYOSIL E1549 is an acrylic emulsion polymer designed for manufacturing primers and topcoats for interior wood. It provides good early sandability after short drying.

是一款丙烯酸乳液聚合物，為家具或室內木器底漆和面漆所設計。提供好的打磨性和快干性能。

Characteristics特性

Re免費信息mended as a sealer.  It gives excellent clarity when is applied on both dark and light woods.

 推薦為“在工廠用打磨填孔劑”具有清晰通透的質感，可以適于明或暗的木材。

The excellent selfcrosslinking chemistry is responsible for its fast curing time, good stain and block resistance.  優異的自交聯化學特性，支持快速固化，抗粘連性 。

Advantages 優勢

ü      Good capacity of tannin blocking. 好的單寧阻止性

ü      Early sandability 初期的打磨性。

ü      Excellent alkyd adhesion, wet and dry.優異的醇酸樹脂附著力，濕法和干法

ü      Excellent resistance to household chemicals優異的抗家用（日用）化學腐蝕性

ü      Low water absorption 低吸水性

免費信息patibility配伍性

THYOSIL E1549 is 免費信息patible with emulsions and resins manufactured by DIRANSA. 

可以與DIRANSA 產的相關樹脂和乳液相配

Typical Properties典型值

These properties are typical, do not constitute specifications

Starting Formulation基礎配方（底漆）

1: Dow; 2: Byk Chemie

Typical properties: 典型特性（底漆）

Application應用

·         A smooth surface is obtained by sand the wood with #150-320 grit sandpaper.

·         用# 150 - 320砂紙把木頭的表面打磨光滑。

·         After applying a first coating, wait until it gets dried.  Then sand the applied wood using #320 grit sandpaper.

·         油完第一層后，等到它變干。然后再使用# 320砂紙打磨。

·         A second coat is applied and the wood is left for two weeks driying before performing the quality tests.

·         油完第二層后，放置2周后測試其品質性能。

Formulation Tips 配方提示

»Coalescent（成膜助劑）: THYOSIL E1594 could be used at normal temperatures with the addition of coalescing solvents.  The selection of an optimum coalescing system depends on the required drying rate, temperature and relative humidity.  It is usually re免費信息mended 30% of coalescing solvents but it may be used lower levels depending on the porosity of the substrate, the type of application equipment, moisture conditions and co-solvents used in the formulation. Reducing the amount of coalescent allows faster drying but an excessive reduction may result in poorer film formation and consequently the loss of the stain resistance. Various types of coalescing may be used.  It must be determined for each application.
It is re免費信息mended to allow the formulations equilibrating for at least 8 hours after addition of coalescing agents to obtain consistency results in the tests performed.

THYOSIL E1594  可以在常溫下可以與溶劑混合，根據所需要的干燥速度,溫度和濕度，選擇最佳的配比。可以在常溫下可以添加成膜助劑，根據所需要的干燥速度,溫度和濕度，選擇最佳的配比。通常推薦使用 30%的成膜助劑（與配方中E1594的固含量相比），也可以低于或高于此水平，取決于基材的具體特性，所使用的設備，水分含量等條件。減少成膜助劑的使用干燥速度會快，但若添加太少會影響成膜性，同時還會減少防污性能。可以使用各種成膜助劑，它必須適合所需要的應用，添加的成膜助劑要8小時前后測試結果沒有變化。

»Rheology Modifiers:  流變改性劑We suggest the use of associative thickeners. Keep in mind that the efficiency of urethane associative thickeners depends largely on the selection of coalescing adopted

我們推薦使用締合型增稠劑，記住聚氨酯締合增稠劑的效果取決于成膜助劑的選擇。

»Antifoam: 消泡劑Antifoam should be tested in each case.  Care must be taken with the concentration chosen as an excess of antifoaming can cause fish eyes defects or loss of transparency of the film.      

消泡劑的使用要根據不同情況提前測試 ，添加過量會導致魚眼的產生或膜的透明度                                         .

»Wetting agents: 潤濕劑 They are additives that promote good flow and levelling properties.  These additives must be adjusted carefully as microfoam generally cause defects

可以改善流平性，添加時要注意微泡導致的缺陷

»Biocides: THYOSIL E1594殺菌劑 is sufficiently protected against bacterial attack during transport and storage. For adequate protection to micro電子商務anisms during storage of the preparations made, 0.2% of IPEL BP20* is suggested. It is 0.25% of IPEL FBP71 * for protection against fungi and algae film. (*Itibanyl Productos Especiales S.A.)

產品在儲存和運輸中具有防止細菌滋生的功能。在儲存時為防止微生物的的滋生可以添加0.2%BP20*殺菌劑。為防止成膜后產生真菌和藻類可以添加0.25%的 FBP71.

Safe handling Information

Before using this product, read carefully the Material Safety Data Sheet (MSDS).

Important: Avoid freezing. 注意防凍